Re: AW: [HBF] Rotationsanschwänzer

[Dan Listermann]

Consider opening the spray holes a bit.  They are now about 0.65 mm.

Dan Listermann


----- Original Message ----- 
From: "Thomas Rohner" <t.rohner at bluewin.ch>
To: "Hausbrauerforum" <hbf at lists.netbeer.org>
Sent: Friday, February 25, 2005 9:25 AM
Subject: Re: AW: [HBF] Rotationsanschwänzer


> Hi Dan
>
> thank you for answering my "problem". My sparger doesn't rotate mainly
> because i removed the rubber plugs on both ends. The flow rate would
> be too low with the plugs in. I guess my version is for 5 gal batches.
> So i don't use it the intended way but it works anyway.
>
> thanks again  Thomas
>
>
>
> Dan Listermann schrieb:
>> Entschuldigen Sie mir, aber meine Hochschule Deutsch ist nicht gut.  Ich
>> muss Englisch schreiben.
>>
>> If the sparge arm does not rotate, the likely cause is a bent wire at
>> the joint of the arm where the little ball that holds the assembly
>> together. Try to see if you can straighten this wire by pushing on the
>> ball.
>>
>> Maybe Phil can translate.
>>
>> Dan Listermann
>>
>
>
>


--------------------------------------------------------------------------------


_______________________________________________
HBF mailing list Mailto:HBF at lists.netbeer.org
ListInfo: http://lists.netbeer.org/
Ändern oder abbestellen: 
http://lists.bonis.de/mailman/options/hbf/dan%40listermann.com

Sponsor: Wim Bonis, bonis at bonis.de
Moderatoren: Hubert Hanghofer und Armin Teltschik